Hilantronics Engine Kill Switch & LED Kit 1/5 RC 2 3 & 4 CH
[Kill Switch 2,3,4chkit]

Aussie Designed & Made  Hilantronics Electronic Kill Switch Kit Prewired for 1/5 2 Stroke Petrol RC  with 2 , 3, 4 Channel Radio

Spark Killer,Is the latest in the next generation of RC Kill Switches with switchable low voltage cut off .This version now can be used for 2,3 & 4 Channel radio's. Also featuring the switcheable low voltage cutout needed for the big and heavy cars produced by Losi and Rovan.

It will kill the engine if interference is detected, the transmitter is switched off (loss of signal), receiver battery goes flat or power is lost to the reciever for any reason. These new kill switches were designed to take into account the higher voltage demands of todays HV servos in cars which use more than 2 servo's ie:Twin steering for Losi 5ive and MCD's.

Bright LED to indicate switch status when the LED is on the engine can start, if its flashing or off the engine cannot start.

Kit  Includes:

• 1x Spark Killer Low Voltage switchable
• 1 x Y cable
• 1 x prewired noise filtered engine stop switch
• 1 x quick disconnect plug
• 1 x remote super bright red LED indicator so the kill switch status signal can be seen externally
• Operation Voltage: 3.3 Volts to 8 Volts
• Relay Voltage Max: 125VAc, 24Vdc
• Contact Relay Current DC Max : 1A
• Relay Coil Resistance : 167 Ohm
• External LED Clip dimension:
• Panel Cut out diameter : 8mm
• Clip Length : 12.5mm
• Jumper settings:
•  Black-Voltage
•  On = 3.3Vdc cut-off voltage
•  Off = 4Vdc cut-off voltage
•  Red-Channel:
•  On = 3,4 channel
•  Off = 2 Channel

 Note: Not suitable for use with Spektrum radios using Telemetry *Not compatible with 2 channel Spektrum AVC receiver and  2 channel HPI TF-20  radio

Note: *Not compatible with 2 channel Spektrum AVC receiver and  2 channel HPI TF-20  radio