4000mAh 7.4v LiPo Receiver battery pack.
Lipo Receiver Battery more run time less weight .
DDM Racing 4000 mAh LiPo receiver battery for the HPI Baja. This battery is designed to be a direct replacement for the standard NiMH 5 cell battery included with the Baja and fit inside the battery box. Features flexible 22 awg wire with a JR style servo connector and an XH type balance plug. There are two leads, one made to plug into your on/off switch and another for charging.
71mm x 52mm x 19mm
Before use make sure that your receiver and electronics are LiPo/high voltage compatible. Use with non-compatible electronics may damage your receiver/servos. Requires a LiPo battery charger. When not in use for extended periods it is suggested that the battery is placed in "Storage Mode" with your LiPo charger.
for use with High Voltage compatable servos or with a 6V voltage step down module (availble in store)
A LiPo compatible charger is required carefully follow directions for lipo batteries and due care in using proper charging settings and a lipo fire proof bag is recomended for charging and storage
Battery Charging Guide :
A basic estimate for a manual charger can be obtained by dividing the mAh rating of your batteries by the charging current. e.g. 2000 mAh batteries charged at 500 mA should require about 3.6 hours. It is recommend you stick with the basic estimate, as it is always preferable to undercharge batteries than overcharge them.
Batteries charging they should not be left unattended or power left on over the time estimated as damage may result .
Batteries should not be charged in confined space where overheating may occur
Keep Battery Charging away from any fuel source if on a Nitro or 2-Stroke RC
*BE SURE CAR IS SWITCHED OFF WHEN CHARGING OTHERWISE DAMAGE WILL OCCCUR *